Sole Fitness 16608706000, Руководство пользователя

Страница: 13 / 40

CONSOLE ASSEMBLY
Stpe 1. Remove the four screws (G1) from the back of
console (G).
Step 2. Connect console wires (D1,D3,G3,G4) and heart rate
wires (D4) to the console. Heart rate wires can be
interchangeable.
Note : Make sure the wires are connected together properly.
Push and store excess wires back into the console
supporting tube (D). Be careful not to pinch the
wires while assembling the console.
Step 3. Hand tighten the four screws (G1)
at
first,
then use the screw driver to tighten the
four screws (G1) to secure the console (G)
onto the console supporting tube (D).
Step 4. Adjust the levelers on the bottom rear of
supporting tubes to stabilize the machine.
USE TOOL:4mm
(Phillips Screw Driver)
CONSOLE SUPPORTING TUBE
AND BOTTLE HOLDER ASSEMBLY
Step 1. Connect wires (D1 & D2) from the console
supporting tube (D) to wires (A1 & A2) from the
main frame (A).
Step 2. Slide the console supporting tube (D) onto the
main frame (A). Store excess wires into the tube. If
needed, loosen the pre-installed screw (J13)
slightly in the main frame (A) to help slide console
supporting tube down or to help align holes for
the screws (J13).Be careful not to pinch the wires
while assembling the tube.
Note : Make sure that all wires are
connected
together properly; all screws
(J13) are tight
ened
to prevent
the
console
support tube
from becoming loose
.
Step 4. Use the two screws (J14) located in the
water bottle holder bag to
attach
the
water bottle holder (H) to the main
frame (A).
USE TOOL:4mm
5mm
D1
A2
A1
A
H
J14
J13
J13
J13
J13
D
D2
G
G1
D
D1
D3
D4
G4
G3
Step 3. Using the 5mm allen wrench firmly tighten the four
screws (J13).
- 1 2 -