25
Dyaco Canada Inc. 2018
CALIBRATION PROCEDURE
1.
Remove the
Safety Key
.
2.
Press and hold down the
Start
and
Fast
buttons and replace the
Safety Key,
then press the
Enter
key.
3.
You will now be able to set the display to show mile or km settings (Miles vs. Kilometers). To do this, press
the
Fast
/
Slow
key to show which you want, then press
Enter
.
4.
Adjust the minimum speed (if needed) to 0.8kph/0.5mph and then press
Enter
.
5.
Adjust the maximum speed (if needed) to 5.0kph/4.0mph.
6.
Press
Start
to begin calibration. The process is automatic; the speed will start up without warning, so do
not stand on the belt.
ADJUSTING THE SPEED SENSOR
If the calibration does not pass you may need to check the speed sensor alignment.
1.
Remove the motor cover hood by loosening the 4 screws that hold it in place (you do not need to remove
them completely).
2.
The speed sensor is located on the left side of the frame, right next to the front roller pulley (the pulley
will have a belt around it that also goes to the motor). The speed sensor is small and black with a wire
connected to it.
Make sure the sensor is as close as possible to the pulley without touching it. You will see a magnet on the
face of the pulley; make sure the sensor is aligned with the magnet. There is a screw that holds the sensor in
place that needs to be loosened to adjust the sensor. Re-tighten the screw when finished.
ERROR MESSAGE:
1.
LS:
Treadmill doesn’t receive the speed signal for 8 seconds.
2.
E1:
Memory of console malfunction or CPU accessing problem.
