background image

solasfires.com

3

LOG SET INSTALLATION

2.  Figure 2 shows the screw on the right underside of 

the firebox which secures the front of the valve bracket, 

remove this screw. Keep this screw in a safe place a 

it will be needed to secure the valve bracket again 

once the logset burner is installed.

    

3.    The valve bracket is still secured by a third screw, 

without removing this screw, the valve bracket and 

valve can be pulled down approximately ½” (12mm) 

as shown in Figure 3.

    

    

4.    The burner is held in place by 4 sheet metal screws, 

2 on the left and 2 on the right. Figure 4 shows 2 

screws on the left under side of the firebox, remove 

these screws. Keep these screws in a safe place as 

they will be needed to install the Log Set burner.

    

5.    Figure 5 shows the 2 screws on the right underside of 

the firebox, remove these screws. A 5/16”, 6” or longer nut 

driver will make removal of these screws easier. Keep 

these screws in a safe place as they will be needed to 

install the Logset burner.

    

6.   To remove the burner from the fireplace, slide the 

entire assembly to the right before lifting up to 

remove as shown in Figure 6.

    

7.  Once the glass media burner has been removed, 

locate the Logset burner included in the kit LGS-16 

as shown below in Figure 7.

    

Figure 3

Figure 4

Figure 2

Figure 5

Figure 6

Figure 7

Отзывы: