Solas-Nua FS-16N RV, Руководство по установке и эксплуатации

Страница: 15 / 40

15
ASSEMBLY & INSTALLATION
Venting Installation:
The Solas Nua Freestanding Stove is shipped with a custom Simpson DuraVent GS® starter section that
is specifically designed for the Solas Nua.
Regardless of the venting brand you chose, you must use
the starter section provided . All of the venting brands listed for use with the Solas Nua Freestanding
are compatible with the starter section provided . For venting system installation details, refer to the in-
structions provided with the venting system you have chosen. Each brand has specific installation re-
quirements that must be followed to insure a safe and functional venting system for your stove.
The Solas Nua Freestanding is shipped from the factory configured for either Rear Venting or Top
Venting as requested.
Prior to connecting your vent system to the stove, please refer to the venting section (pages 7-13) of this
manual to determine whether your installation will require the addition of flow restrictors to the com-
bustion air inlet system or the exhaust outlet or both. Refer to the venting section that starts on page
7
to make that determination.
If your installation does require an air restrictor or exhaust restrictor or both, these must be installed be-
fore you connect your vent system to the stove. Again, refer to the venting information starting on page
8 to determine the specific restrictor requirements for your specific installation. To install the Air Intake
and Exhaust Restrictors please proceed as follows:
1. Remove the top panel of the stove by unscrewing the 4
decorative fasteners.
2. Remove the rear panel of the stove.
3. Remove the Vent adapter attached to the unit by 4 #10
Sheetmetal screws, taking car not to damage the ceramic fiber
gasket.
4. The exhaust restrictor is installed by placing it through the
exhaust outlet pipe and resting it on the internal baffle in the
firebox. It is held in place with a movable retainer clip. Sim-
ply hold the restrictor down against the baffle and push the
retainer up and tighten screw to secure the restrictor. Note:
Please take care to insure that the exhaust restrictor is cen-
tered in the exhaust outlet. Improper alignment could ad-
versely affect the appearance of the flames. Refer to the adja-
cent photographs for placement of the exhaust restrictor and
clip.
INSERTING THE EXHAUST
RESTRICTOR
EXHAUST RESTRICTOR
PROPERLY INSTALLED