nOte
It is not permitted to use SOLARWATT solar modules as overhead glazing. For roof installation, these solar modules may only be installed
over a fi re-resistant roof covering.
Fastening on long sides
The maximum pressure load to the solar module for
the installation method is 3,500 N/m².
Fastening on short sides
In addition, this fastening mode requires a central,
round or linear support on the lower frame side (cen-
tral support). The maximum pressure load to the solar
module for the installation method is 2,400 N/m².
Horizontal installation
inseRtiOn sYsteM
Fixed in place by inserting in a supporting frame
3
Vertical installation
The maximum pressure load to the solar module for
the installation method is 2,400 N/m².
areas approved for
fastening
Additional system-specifi c load limits can be found in the download area
at www.solarwatt.de.
4
nOte
Under mechanical load, no contact between solar glass and hard materials (eg. metal, glass) may occur. The drainage holes in the module frame
must not be covered, as it could cause frost damage on the module frame. Do not place any plug connectors in the frame.
16
0
m
m
16
0
m
m
16
0
m
m
16
0
m
m
200 mm
200 mm
13
Subject to change | © 2016 SOLARWATT GmbH | AZ-TM-PMS-0973 | Rev 008 | Status: 11/2016
