clAMPing sYsteM
Fix in place with suitable module clips
2
The bracket must not distort the solar
module and the clips must not come into
contact with the front pane. Please pay
attention to the clip manufacturer’s
specifi cations. The clip surfaces must be
suffi ciently sized (areas of 400 mm² per
fastening point are required).
areas approved for fastening
Fastening on long sides
The maximum pressure load to the solar mod-
ule for the installation method is 2,400 N/m².
Fastening on short sides
The maximum pressure load to the solar mod-
ule for the installation method is 2,400 N/m².
Vertical installation
scReW fiXtuRes
Fastening on the fastening holes with screws.
Only use the holes provided in the frame (diameter: 9 mm).
1
Fastening on the fastening holes
The maximum pressure load to the solar module for
the installation method is 2,400 N/m².
SOLARWATT modules can be fastened in a number of ways:
20
0
m
m
20
0
m
m
100 mm
100 mm
Subject to change | © 2016 SOLARWATT GmbH | AZ-TM-PMS-0973 | Rev 008 | Status: 11/2016
12
