SOLARFOCUS Vampair, Руководство по установке

Страница: 33 / 52

8 Electrical connection
8.6.5 Connect RS485 bus
►
Establish the bus cable connection from the dis-
play to the electrical terminal area of ​​the heat
pump.
►
220 Ω resistor in connector X5 (on display).
Display
X5
Terminal area
X5
RS485 A Pin 1 or 3 A
RS485 B Pin 2 or 4 B
GND Pin 5 GND ⏊
8.7 Connect electronic module D1
i
Note on terminal designations in the electronic
module:
O or o stands for output , I or i stands
for input .
►
Loosen 4 screws and remove the module cover.
8.7.1 Terminal assignment - overview
i
You can find detailed information about the
connection of the individual components on
the following pages.
Abb. 2-42: Electronic module (type universal module )
Connection Function
CAN-IN Bus cable
CAN-OUT Bus cable
X1 Power supply for the electronic module -
230 V AC
X2 230 V AC output (e.g. for further elec-
tronic modules)
i1 Switching contact (input) for heating cir-
cuit
[1]
> 35
i2 Temperature sensor tank (buffer tank,
domestic hot water tank)
i3 Flow sensor
i4 Return sensor
For
vamp
air
K 08, K 10
i4 "Return sensor", measurement of the
return temperature by means of flow sen-
sor (Huba Control)
For
vamp
air
K 12, K 15
i5 Digital input for Smart Grid
[1]
i9 Digital input for Smart Grid
[1]
i15 Flow sensor (made by Huba Control) -
measurement of the flow rate
For
vamp
air
K 12, K 15
o1 Primary circuit circulation pump - power
supply
OUT1 Primary circuit circulation pump - control
signal
o2 Three-way ball valve
[1] Only connect potential-free contact.
8.7.2 Connection of the bus cable
!
CAUTION
–
Risk of destruction of the electronic
module or control components if terminals
are incorrectly assigned.
–
Lay the bus cable/sensor cable (low
voltage) and power cable (230 V)
separately.
–
Where a bus cable (with separate earthing
systems) extends over more than one buil-
ding install a CAN bus repeater to gal-
vanically isolate the bus (e.g.
SOLARFOCUS Art. 61610).
!
CAUTION - Note different versions of the
CAN-IN terminal depending on the type of
electronic module.
–
Type universal module:
3-pole, A B
⏊
–
Type heating circuit basic module and hea-
ting circuit extension module:
4-pole, + A B
⏊
Installation manual vampair 33