2. To allow proper heat dissipation, maintain the following minimum clearance areas
between the inverter and other objects:
Figure 16: Clearance areas
If installing a single inverter:
8" (20 cm) from the top of the inverter.
At least 4" (10 cm) from the bottom of the inverter; if conduit entry to the Safety
Switch will be from the bottom, leave sufficient clearance for the conduits as
well.
4" (10 cm) from the right and left of the inverter.
If installing multiple inverters:
When installing inverters side by side, leave at least 20 cm (8") between inverters.
When installing inverters one above of the other, leave at least 16" (40 cm)
between inverters.
3. Position the mounting bracket against the wall/ pole and mark the drilling hole
locations (refer to
Mechanical Specifications on page 67 for inverter and mounting
bracket dimensions).
4. Drill the holes and mount the bracket. Verify that the bracket is firmly attached to
the mounting surface.
5. Hang the inverter on the bracket:
Chapter 3: Installing the Inverter
33
Single Phase Inverter with HD-Wave Technology Installation MAN-01-00541-1.4
Содержание UL1741-SA
Страница 82: ......
