| 3
April 2020 | Solar Stik®, Inc.
PRO-Verter 5000-240 Filter Board Replacement
1. Remove the twenty-two (22) fasteners
around the perimeter of the PRO-Verter
Faceplate (see orange circles, right) using a
#2 cross-tip screw driver. Retain hardware for
reinstallation.
2. Lift the left side of the PRO-Verter Faceplate
and swing it open to the right. Support
the Faceplate to prevent stressing wired
connections between the Faceplate and the
interior of the PRO-Verter.
The orange rectangle indicates the location of
the Filter Board.
3. Label each of the four (4) wires on the left
side of the Filter Board. The four (4) white
wires on the right side are already labeled
(e.g., S1=Start 1, F1=Finish 1). Disconnect the
labeled wires.
