Solahart Continuous Flow, Руководство пользователя

Страница: 10 / 40

10
WATER SUPPLIES
This water heater must be installed in accordance with this advice to be covered by the Solahart
warranty.
This water heater is manufactured to suit the water conditions of most public reticulated water supplies.
However, there are some known water chemistries which can have detrimental effects on the water heater
and its operation and / or life expectancy. If you are unsure of your water chemistry, you may be able to
obtain information from your local water supply authority. This water heater should only be connected to a
water supply which complies with these guidelines for the Solahart warranty to apply.
CHANGE OF WATER SUPPLY
The changing or alternating from one water supply to another can have a detrimental effect on the operation
and / or life expectation of a heat exchanger in a continuous flow water heater.
Where there is a changeover from one water supply to another, e.g. a rainwater tank supply, bore water
supply, desalinated water supply, public reticulated water supply or water brought in from another supply,
then water chemistry information should be sought from the supplier or it should be tested to ensure the
water supply meets the requirements given in these guidelines for the Solahart warranty to apply.
SATURATION INDEX
The saturation index (SI)
is used as a measure of the water‟s corrosive or scaling properties.
In a corrosive water supply, the water can attack copper parts and cause them to fail. Where the saturation
index is less than
–1.0, the water is very corrosive and the Solahart warranty does not apply to a copper heat
exchanger in a continuous flow water heater.
In a scaling water supply calcium carbonate is deposited out of the water onto any hot metallic surface.
Where the saturation index e0.80, the Solahart warranty does not apply to a copper heat exchanger
in a continuous flow water heater.
Water which is scaling may be treated with a water softening device to reduce the saturation index of the
water.
Refer to the
Saturation Index chart on page 10.
-1.0
no
warr
anty
a
pp
li
e
s
to
a
:
-c
o
n
ti
n
u
o
u
s
f
lo
w
c
o
p
p
e
r
h
e
a
t
e
x
c
h
a
n
g
e
r
SATURATION INDEX (SI)
GAS CONTINUOUS FLOW WATER HEATERS
WITHIN WARRANTY
SPECIFICATION
SATURATION INDEX
(calculated @ 80°C water temperature)
no
warr
anty
a
pp
li
e
s
to
a
:
-c
o
n
ti
n
u
o
u
s
f
lo
w
c
o
p
p
e
r
h
e
a
t
e
x
c
h
a
n
g
e
r
+0.4 +0.8 0
very corrosive very scaling scaling
corrosive