12
COMMISSIONING
5. COMMISSIONING
The issues to take into account before starting the machine
are detailed below:
• Verify that the mechanical components are well greased.
Periodically grease the mechanical components (see sec-
tion 9.4 LUBRICATION AND GREASING POINTS).
• Verify the tyre pressure (see section 9.5 TYRE PRESSURE).
• Verify that the hydraulic circuit conducts of the machine
and the pneumatic conducts (seed transport) are in good
conditions.
After coupling the seed driller with the tractor:
• Verify that the machine is correctly attached to the tractor.
• Before starting the machine, get familiar with all its compo-
nents and adjustments.
• Start the machine being empty in order to free the con-
ducts form any condensation of water or possible dirt.
• Adjust the machine and all its components, the type of ter-
rain and the seed.
5.1 COUPLING THE SEED DRILLER TO
THE TRACTOR
The
A-6000/NS PLUS
seed driller is fitted with a rotating
shaft-ring hook.
MAKE SURE THAT NOBODY AND NOTHING IS
BETWEEN THE TRACTOR AND THE SEED DRILL-
ER WHEN COUPLING AND UNCOUPLING.
THESE PROCEDURES REQUIRE PAYING MAXI-
MUM ATTENTION TO AVOID DAMAGE TO THE
OPERATOR.
MACHINE COUPLING AND UNCOUPLING PRO-
CEDURES MUST BE CARRIED OUT WITH THE
SUPPORT FEET AT THEIR LOWEST POSITION.
Follow the steps below for the coupling manoeuvre:
1-
Plug in the hydraulic circuit connectors of the machine
to the tractor distributor, for:
1.1
- FOLDABLE PARTS OF THE SOWING EQUIPMENT
1.2
- TRACK MARKERS
1.3
- SOWING EQUIPMENT AND TRACK ERASER
1.4
- HYDRAULIC TURBINE
1.5
- HYDRAULIC SERVICE BRAKE
THE NECESSARY HYDRAULIC CONNECTIONS
FOR THESE ELEMENTS ARE SPECIFIED IN SEC-
TION 5.3 HYDRAULIC SYSTEM.
FOR MACHINE VERSIONS WITH HYDRAULIC
TURBINE, CARDAN TRANSMISSION MUST BE
ADAPTED ONCE THE MACHINE IS COUPLED TO
THE TRACTOR (SEE SECTION 5.2 COUPLING AND
ADAPTING THE CARDAN TRANSMISSION).
2-
Plug in the electrical connector for the lightning
equipment.
3-
Place the front support feet in vertical position (see sec-
tion 5.6 SUPPORT FEET).
4-
Lower the central sowing equipment until touching
the ground.
5-
Hook the seed drill rotatory ring to the tractor at the
towing hook point. (Fig. 7).
Fig. 7
IF THE HOOK POINT IS TOO LOW, SEE
SECTION 6.1.1 TOW-BAR AND TRACTOR
LEVELLING.
6-
Lift the machine support foot.
BEFORE MOVING THE MACHINE, MAKE
SURE IT IS CORRECTLY HOOKED TO THE
TRACTOR.
FOR UNCOUPLING THE MACHINE AND THE
TRACTOR, PERFORM THE STEPS IN THIS SEC-
TION INVERSELY.
Содержание A-6000/NS PLUS
