background image

- 8 -

- 5 -

Front Panel (320VA-1200VA and 1500VA)

1)  “ REPLACE BATTERY “ indicator (RED LED): 

The LED illuminates when the UPS’s battery is 

no longer useful and must be replaced.  

 

Caution: Do not attempt to open the UPS or 

replace the battery. Call technical support 

(800-377-4384) when battery replacement 

 

is required. 

2)  “ BACK UP” indicator (YELLOW LED): 

 

The LED illuminates when the UPS is 

 

supplying battery power to the loads.

3)  “ LINE NORMAL” indicator (GREEN LED):  

 

The LED illuminates when the line input 

 

voltage is normal.

4)  “ ON/OFF/TEST” button: 

 

Press the button more  
than 1 second to turn the UPS on or off, press 
the button less than 1 second to activate the  

UPS’s self-testing. Press for more than 

 

2 seconds to turn off.

Alarms

1.  

“BACK UP” (slow beeping)

  

   

  When in BACK UP mode, the YELLOW LED illuminates and the UPS sounds 

an audible alarm. The alarm stops when the UPS returns to LINE 

 

NORMAL operation.

2.   

“LOW BATTERY”  (rapid beeping)

       In BACK UP mode when the battery energy runs low, the UPS beeps rapidly 

until the UPS shuts down from battery exhaustion or returns to LINE 

 

NORMAL operation.

3.  

“OVERLOAD”  (continuous alarm)

       When the UPS is overloaded (the connected loads exceed the maximum rated 

capacity), the UPS sounds a continuous alarm and LED to warn of an overload 
condition.  Remove non-critical loads from the battery power outlets to 

 

eliminate the overload.

320VA - 1200VA

1500VA

Rear Panel (320VA-1200VA)

5)  TEL/SURGE PROTECTION

6)   INPUT CIRCUIT BREAKER: Protection from 

AC overload and Short-circuit.

7)  AC INPUT POWER CORD

8)  UPS OUTPUT OUTLETS (Black) 

9)  SURGE PROTECTED OUTLET (White)

5)  “ LED indicator: 

 

The LED indicator indicates the UPS’s status.  The indicator is illuminated 

steady when the UPS is supplying utility power to the loads.  The indicator 

flashes slowly (about once every 2 second) when the UPS is supplying 

 

battery power to the loads.  The indicator flashes rapidly (about once every 

 

0.5 second) when loads connected to the UPS exceed the UPS’s capacity.

* 650 VA and above models

Содержание S1K320









Отзывы: