Sola HD S1K Series, Инструкция по эксплуатации

Страница: 9 / 16

S1K Series Instruction Manual • 9
5.0 Operating Instructions
5.1 UPS Protected Output Outlets
The output outlets will provide protection from surges and power failures. Plug
your computer, monitor, and other “data critical” devices into these outlets.
5.2 Surge Protected Outlet Only
The surge protected outlet can offer protection against surges and transients
typically caused by lightning or disruptive loads in the building. In the event of
utility power failure, this outlet will not provide backup power to the load. Utilize
this outlet with less critical devices such as printers, scanners, fax machines, or
external speakers.
5.3 Switch On
With the UPS plugged in, press and hold the On/Off/Test button for more than 1
second until the Line Normal LED is lit. The UPS will perform self-testing each
time it is switched on.
5.4 Switch Off
Press and hold the On/Off/Test button for more than 2 seconds until the Line
Normal or Backup LED turns off.
5.5 Self-test
Use the self-test function to verify both the operation of the UPS and the condi-
tion of the battery. In normal utility power, press the On/Off/Test button for less
than 1 second to perform a self-test function. During the self-test, the UPS runs in
Backup Mode. If the UPS passes the self-test, it returns to Line Normal operation.
5.6 Green Mode
If a load of <20 watts is connected to the UPS and the ac power fails or is discon-
nected, the UPS will enter the Green Mode. At this time, the green LED on the
front panel will flash every 3 to 5 seconds. After approximately 3 minutes, the UPS
will shut down, preventing a deep discharge of the battery. The UPS will return to
Line Normal operation when ac power returns.
If the UPS is in the Battery Backup Mode and the load is decreased to <20 watts,
the UPS will again enter the Green Mode and will shut down within 3 minutes.
Application of ac power will return the UPS to Line Normal operation.
If the Green Mode of operation is not desired, it can be disabled by holding
down the On/Off/Test button until two beeps are heard. The Green Mode will be
disabled and will remain in this mode until the UPS is turned off.