29"
73.6cm
ALIGNMENT
MOUNTING BOLT
29"
73.6cm
The Sohn Model 4400 should be lifted from the back only (see Figure 1).
(see Figure 1A).
To stabilize the machine and avoid potential damage to the control panel, forks should be spread 29" (73.6 cm) apart from outside edge
of fork to outside edge of fork. The forks should extend slightly past the front base plate but not past the mounting bars (see Figure 2).
The table is to be picked up in the same manner as the machine (see Figure 3).
Figure 4 shows the machine being placed on the table in the correct position.
The machine must be securely anchored to the table. Align the holes in the mounting bar with the pre-tapped holes in the top of the table
(see figures 4, 5 and 6). Start at one corner and screw the mounting bolt from the inside hole of the mounting bar into the table top. Snug
the bolt but do not tighten. Proceed to the opposite corner and repeat the process, then continue until all six bolts are in place. Once all
bolts are in place, tighten all.
NOTE: DO NOT USE PANEL HANDLE AS A LIFTING POINT
1
Fig. 1
Fig. 3
Fig. 5
Fig. 6
Fig. 4
Fig. 2
FORKS
BASE
PLATE
MOUNTING BARS
Fig. 1A
Содержание 4400
Страница 2: ......
