Sogno CX, Быстрый старт

Страница: 18 / 24

Operation of the Receiver
18 ENGLISH

Connect TV set and receiver by using an
HDMI cable or connect TV set and receiver
by using a SCART cable.
2.4 Connecting a Data Storage Device
 Connect a data storage device (USB stick
or hard drive with USB connection) at the
USB connector to be able to access
MPEG, MP3, JPG or other media data files.
2.5 Connecting a Home Cinema Sys-
tem
To improve audio playback, you can connect
to the receiver - additionally to the TV set - also
a multichannel home cinema system or a hi-fi
system. There are various possibilities for
connection. Your type of connection depends
on the connection possibilities of your home
cinema system.
• Your home cinema system is able to loop
through an HDMI signal, i.e. HDMI connec-
tion for receiver and HDMI connection for
TV set.

Connect the home cinema system and
the receiver by using an HDMI cable as
well as home cinema system and TV
set by using an HDMI cable.
• Your home cinema system provides a
cinch connection for digital audio data.

Connect the home cinema system and
the receiver by using a RCA cable.
•
Your home cinema system cannot process
digital audio data.

Connect the home cinema system and
the receiver by using a 2-pole RCA ca-
ble (stereo).
2.6 Insert Batteries of Remote Control
This describes the steps for inserting new
batteries of the remote control or for replac-
ing empty batteries:
1. Open the battery compartment on the
bottom side of the remote control. Remove
the cover of the battery compartment.
2. Place the two batteries 1.5 V (type: AAA).
Ensure correct polarity!
3. Close the battery compartment


Replace the batteries if certain
remote control functions are not
performed any more or are per-
formed incorrectly.
 When replacing batteries, al-
ways ensure that all batteries
are replaced.
3 Operation of the Receiver
This chapter describes the required steps to be
able to use the offer of radio and TV channels
provided via satellite.

In order to simply the presenta-
tion in the following sections the
keys for the horizontal menu
navigation
and will
be called V+ and V- (V for Vol-
ume).
3.1 Switch on Receiver
1. Switch on all connected devices.
2. Ensure that the correct AV input is selected
at the TV set (i.e. that the signals from the
receiver are displayed).
3. Connect the mains plug to the power outlet
to switch on the receiver
or
Connect the mains plug to the power outlet
and switch on the receiver by using the
power switch (on the rear panel of housing)
(I, ON).
3.2 Installation
After first switching-on or after resetting the
receiver, various windows will open:
3.2.1 Menu Language
By default, the Receiver language is preset to
Deutsch [
German
].