17
Set Up Menus
(See Figure 8
—Set Up Menu Map, Page No. 13)
There are two paths for changing the settings:
A.
The “General Setup Menu” changes the settings for:
•
Feet or Meters when measuring cable length
•
Setting the capacitance value for a specific cable
•
Turning the audible beep on/off
B.
The “Set Pass Criteria Menu” allows you to set the PASS parameters for
a specific configuration including:
•
Shielded or unshielded detection
•
Single or multiple pairs
•
Cross-over (X-Over) for data cables
•
Reverse-wired phones cables
In the “ANY” Cable Configuration setting, the CableMaster 500 will test
the cable for a standard TIA568 configuration and display UTP if no
continuous shield is detected or STP if a continuous shield is detected.
It is likely that you will use this setting for most if not all your testing, but
the custom settings will allow you to test specific configurations.
NOTE: To access the
Set PASS Criteria menu
, you must press and hold
down the
SETTINGS
button for more than 2 seconds.
When editing a setting, press the Setup button to return to Setup loop
without saving. Pressing the OK button saves the setting and returns
to the Setup loop menu. Pressing the Test key saves the current setting
and returns to the testing mode. Pressing the Mode button discards
any changes to the current setting and returns to the Mode select loop
menu.
Содержание CableMaster CM500
Страница 23: ...23 NOTES...