深圳硕飞科技有限公司
SHENZHEN SOFI TECHNOLOGY
User's Guide
21
SP8 Seriel programmer
You should choose the right format, otherwise you might fail in loading the file, and thus the chip to be programmed
would work abnormally.
After the file is loaded, if you perform the operation to write, the content in the buffer will be covered by the read
data. To re-program its content to the chip, you must re-load the file.
Save files
The data in the buffer can be saved into the hard disk as a file following the steps below:
Click [File] -> [Save file] or the toolbar button "Save", and in the file dialog that bumps out later, choose the path
and file name to be saved, as shown below:
Then there will be a setting dialog Save Files. Parameters include file type, start address in the buffer, and data
size to be saved.
File type
According to the file's extension, the software
automatically chooses a default type for this file. To
save in other formats, please choose again.
Start address in the buffer
User can save part of the data in the buffer by
setting this option. If the value is not set 0, the data
before this address will not be saved to the file.
Data size
The number of bytes to be saved. Input format is
hex.
Note: All data to be entered must be hex.
