18
ADJUSTMENT OF THE CHIN STRAP
The chinstrap (Fig. 3) has a length adjustment, individually for the left and right of the
strap. For each part, the length of the front (1) and rear (2) sections can be changed by
sliding the strip through the splitter (3).
FASTENING OF THE CHIN STRAP
To fasten the strap, insert the strap element (1) into the clip (2) (Fig. 4) To unfasten the
strap, pull the clip (1) and release the strap element (2) from the clip (Fig. 5).
OPENING/CLOSING OF THE FACE SHIELD
1. To lower (open) the face shield (Fig. 6), gently grab it with both hands, with thumbs
on the inside (1), pull it down (2), until it fully extends to the outside of the helmet (3),
and then turn the chin cover by pulling it towards you (4), until you hear a click of the
hinges of the chin cover
2. To lift (close) the face shield (Fig. 7), first turn the chin cover (5), until you hear a click
of the chin cover hinges (6), and then slide the face shield into the helmet, by pushing it
upward (7).
WARNING! Incorrect (not according to the instruction) use/opening/closing of the face
shield may cause its damage. Do not press on parts of the face shield too hard and do
not close/open it too fast.
4. CHECKS BEFORE EACH USE
The hard hat and the face shield must be checked each time before work is resumed.
During the visual inspection, the following items must be checked:
o
absence of visible defects on hard hat,
o
proper operation of the head circumference adjustment mechanism,
o
proper operation of the chin strap fastener,
o
absence of visible defects on the shield,
o
proper operation of the shield's mechanisms,
o
the period of use or expire date.
In the event of a mechanical damage of the shell (cracks, deep scratches, etc.) or
chemical (discoloration, fading, etc.), improper operation of the head circumference
adjustment or of the chin strap fastener and mechanical (cracks, deep scratches,
perforations), or chemical (discoloration, tarnishing etc.) damage to the face shield or
its malfunction and if there is any doubt as to the optimal level of protection, the helmet
must not be used for work on live equipment and it should be withdrawn from use.
Pay attention to the lifetime of the helmet, which is 60 months from the date of
production marked on the helmet. After this period, the helmet and shield should be
taken out of service and recycled.
If the expire date has passed, the helmet must be disposed of.
If the helmet is wet, it must be completely dried before use.
Содержание ARMOUR-2 ATPV36
