1 9
Hardware Installation Process
M ) Front Audio Connector
D) Floppy / IDE1 / IDE2
1
Floppy
1
IDE2
1
IDE1
G) IR
Be careful with the polarity of the IR connector
while you connect the IR. Please contact you
nearest dealer for optional IR device.
Incase speaker (L)
GND GND GND
Rear Audio
(R)
Rear Audio
(L)
Incase speaker (R)
GND
GND
GND
Front Audio
(R)
Front Audio
(L)
+12V
MIC
1
GND
Rear Audio
(L)
MIC
Front Audio
(R)
GND
1
Rear Audio
(R)
Front Audio
(L)
Type 2
Type 1
There are two types of Front Audio connector, please refer to the tables below before you install.
If you want to use type-1 Front Audio
connector, you must remove 11-12,13-14
Jumper. If you want to use type-2 Front Audio
connector, you must remove 3-4 ,5-6 Jumper.
In order to utilize the front audio header, your
chassis must have front audio connector. Also
please make sure the pin assigment on the
cable is the same as the pin assigment on the
MB header. To find out if the chassis you are
buying support front audio connector, please
contact your dealer.
IRRX
N C
IRTX
GND
V C C
1
