Completion of the Fuz
First, the positions of the RC equipment need to be identified. A battery comprising 4x GP350
Cells, or 350Mah lipo and a 2x D47 servos, about 10g heavy receiver should be suitable to ensure the CG is
approximately right. Smaller amounts of lead are then only for the required for trimming CG.
Once you have established the layout of your RC components, we then complete the wiring harness in the fuz.
Take the 4 pin connector as supplied and use to finish the wiring harness. Make sure the wiring harness is an
appropriate length to reach the receiver. Connect to the wing wiring harness per our earlier work. Next bolt the
wing with the harness to the fuz and you can lock the connector in place using an adhesive such as silicon.
opening in the fuz should be as small as possible
Now, the connector can be glued
Next, the ballast system is prepared. It consists of three milled formers. Tape the two small formers together
so that a 6mm deep end point for the ballast is established. The angle is formed (see picture). A rounding of the
inside edge after makes for easier insertion of the ballast. The recesses on the left and right of the bulk head
formers are for the Kevlar pull cord from the servo’s, and end about 1cm behind the end of the ballast formers.
The bottom recess is for the antenna (unless using 2.4Ghz)
Содержание Stobel V2
Страница 1: ......
