11
IMPORTANT:
To ensure product safety and reliability, repairs, maintenance
and adjustments should be performed by authorized service
centers or other qualified service organizations that utilize
identical replacement parts for their repairs.
Storage
Follow these recommendations for storing the grass t
edger.
• Clean the grass t edger thoroughly before storing.
• Store the t edger in a stable and safe position out
of the reach of children. Keep the t edger in a dry
place where the temperature is not too hot or too cold.
• Do not store the grass t edger resting against the
floor. Hang it by the upper handgrip so that the guard does
not touch anything. If the guard rests against a surface, its
shape and dimensions could be permanently altered, and
could render the machine unsafe to use.
S Support
If your Sun Joe
®
Trimmer Joe TRJ601E-RM Electric Grass
T Edger requires service or maintenance, please call
the
Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563).
Model + Serial Numbers
When contacting the company, reordering parts, or arranging
service from an authorized dealer, you will need to provide the
model and serial numbers, which can be found on the decal
located on the housing of the unit. Copy these numbers into
the space provided below.
Record the following numbers from the housing or handle of your
new product:
Model #:
Serial #:
T R J 6 0 1 E - R M
Troubleshooting
Problems
Possible Cause
Possible Solution
The motor does not
run or the tool runs
slowly.
• Power failure/unit not plugged
into a working receptacle.
• Spool housing cannot rotate freely.
• Cutting line does not protrude.
•
Check to make sure the unit is plugged into a working
outlet. Make sure the extension cord is not damaged.
•
Remove the spool and clean the slots; carefully remove
any grass and weeds or other debris.
• Cut the spool line off so that it just reaches the line
trimming blade.
•
Take the t edger to an authorized service center
if the t edger does not start after completing
these checks.
•
Stop the machine and clean the trimming blade.
•
Install a new spool of cutting line.
•
Clean the bump feed.
•
Remove the spool cover and pull the cutting line until it
reaches the trimming blade.
•
Trimming blade bound with
accumulated grass.
•
Bump feed out of line.
•
Spool bound up.
•
Bump feed is dirty.
• Spool line twisted when refilled.
•
Not enough line is exposed.
Bump line feed does
not work.
