SNOWJOE sunjoe TRJ13STE-RM, Руководство оператора

Страница: 13 / 18

13
Replacing the Spool + Clearing Jams
and Tangled Lines
m
WARNING!
Unplug the extension cord from the main
power plug before changing the trimmer line.
1. Press together both release tabs on the line spool cover
and remove the cover by pulling it straight off (Fig. 23).
2. Lift and remove the sleeve and spool out of the hub
(Fig. 24) and clean out any dirt or grass residue.
3. In case of jams or tangled line, unwrap about 6 inches
(15 cm) of line to ensure that it's not damaged.
4. If it appears undamaged, rewind it and insert each line end
through the two slots on each side of the sleeve. Place the
sleeve over the spool (Fig. 25).
5. Insert each line end through its respective slot on each
side of the hub and gently press the spool down (Fig. 26).
6. Reinstall the spool cover by depressing the release tabs
into their slots in the hub, and push down until the spool
cover clicks into place.
7. Connect the tool to a power source and turn the tool
on. In a few seconds, you will hear the line being cut
automatically to the proper length.
Winding the Line
NOTE: A dual-line factory wound spool (model TRJ13STE-RS-
6PK) is available for easy spool replacement on the TRJ13STE-RM
electric grass t edger. Visit snowjoe.com to purchase
this accessory online. Should you wish to wind the line yourself,
the instructions are provided below. Self-winding, however, is
NOT recommended because if the line is not wound properly it
can cause the trimmer’s auto feed system to malfunction. For this
reason, users are strongly urged to purchase the pre-wound spool.
Fig. 23
Spool cover
Tab
Fig. 24
Spool
Sleeve
Fig. 25
Sleeve
Spool
Slot
Fig. 26
Hub
Slot