SNOWJOE SUNJOE SPX9009-PRO-RM, Руководство оператора

Страница: 10 / 20

10
9. Attach garden hose to water supply (Fig. 9).
m
WARNING!
Do not connect to potable water system.
m
WARNING!
If connection is made to a potable water
system, the system shall be protected against backflow.
m
WARNING!
The intake water temperature must not
exceed 104ºF/40ºC. The water supply must not exceed
0.7 MPa.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive chemicals
will damage the washer.
Operation
Using the Pressure Washer
1. Position the washer as CLOSE as possible to the
water supply.
2. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 10).
3.
Make sure the unit is switched off before plugging the unit
into the power outlet.
4. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the
rating plate.
If the power supply is correct, you may now plug the
pressure washer into the power outlet (Fig. 11).
NOTE:
The GFCI may need to be reset when first plugged
into the electric outlet. Press the "Reset" button until
the power light indicator on the GFCI illuminates when
plugged in.
5. Turn the water supply tap on completely.
6. Make sure the safety lock is down and in its original
position (Fig. 12), then press the trigger for a few seconds
until water flow is steady. This will allow air to escape and
discharge any residual pressure in the hose.
Fig. 8
Garden hose
Water inlet
Fig. 9
Connect to water supply
Garden hose
Fig. 10
RESET
TEST
Fig. 11
GFCI
Power light
indicator
Reset
Fig. 12
Safety lock
Slot
Trigger