SNOWJOE Sunjoe SPX9005-PRO-RM, Руководство оператора

Страница: 10 / 20

10
Operation
Using the Pressure Washer
1. Position the washer as CLOSE as possible to the water
supply.
2. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 9).
3. Make sure the unit is switched off before plugging the unit
into the power outlet.
4. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the rating plate.
If the power supply is correct, you may now plug the
pressure washer into the power outlet (Fig. 10).
NOTE: The GFCI may need to be reset when first plugged
into the electric outlet. Press the "Reset" button until
the power light indicator on the GFCI illuminates when
plugged in.
5. Turn the water supply tap on completely.
6. Make sure the safety lock is down and in its original
position (Fig. 11), then press the trigger for a few seconds
until water flow is steady. This will allow air to escape and
discharge any residual pressure in the hose.
7. Press the ON/OFF switch on the ON(I) side to start the
pressure washer (Fig. 12).
8. When re-starting the motor, always keep the trigger
pressed.
Bypass Mode
When the machine is turned on but the trigger gun is not, the
pressure washer will enter the bypass mode with water flow
circulated inside the pump.
m
ATTENTION!
In any case, DO NOT leave the machine
in bypass mode for more than 2 minutes. Water circulation will
generate heat, which will cause damage to the pump.
Fig. 9
RESE
T
TEST
Fig. 10
GFCI
Power light
indicator
Reset
Fig. 11
Safety lock
Slot
Trigger
Fig. 12
ON/OFF switch