9
10. Attach garden hose to water supply (Fig. 10).
m
WARNING!
The intake water temperature must
not exceed 104ºF/40ºC. The water supply must not
exceed 0.7 MPa.
m
CAUTION!
The washer must only be used with clean
water; use of unfiltered water containing corrosive
chemicals will damage the washer.
11. Make sure the motor switch is pushed to the OFF (0)
position before plugging the unit into the power outlet
(Fig. 11).
12. Check that the electrical supply voltage and frequency
(Volt/Hz) correspond to those specified on the pressure
washer rating plate. If the power supply is correct, you
may now plug the pressure washer into the power outlet
(Fig. 12).
NOTE:
The GFCI may need to be reset when first plugged
into the electric outlet. Press the "Reset" button until the
power light indicator on the GFCI illuminates.
Operation
m
IMPORTANT!
This pressure washer is equipped with
a micro-switch sensitive to water flow. This Total Stop System
(TSS) senses water flow in the pump. When the trigger is
released, water stops flowing through the pump. The TSS then
automatically turns the motor off to protect the pump from
overheating, thus saving energy and prolonging pump life.
1. Position the washer as CLOSE as possible to the water
supply.
2. The washer must be used on a secure and stable surface
in a standing, upright position (Fig. 13).
3. Turn the water supply tap on completely.
Fig. 9
(REAR)
Garden hose
Fig. 10
Connect to water supply
Garden hose
OFF
ON
I
0
OFF
ON
Fig. 11
RESE
T
TEST
Fig. 12
GFCI
Power light
indicator
Reset
Fig. 13
Water inlet
(female coupler)
This end to
water inlet
Garden hose
(male end)
