14
• The air flow can be adjusted when the air regulation
handle is connected. Slide the air block as needed to
adjust the air flow (Fig. 18).
• If needed, use the equipped telescopic tube to reach
further distance. Press the telescopic tube lock and
extended the tube as shown (Fig. 19).
• Turn off and remove the battery after vacuuming, before
cleaning and maintenance. After wet vacuuming, empty
the collection tank, clean and dry the inside and outside
before storage.
• Empty the tank outside in order to avoid a mess.
• Clean or change the filters (see Maintenance section)
if the suction performance deteriorates. Never use the
appliance without the filter.
m
WARNING!
Never remove the powerhead without first
turning the power switch to the OFF position and remove the
battery.
Air Inlet
Never cover the air inlet. Keep it free from obstructions and
debris. It must always remain clear for proper motor cooling.
m
WARNING!
To avoid personal injury, do not wear loose
fitting clothing or articles such as scarves, necklaces, chains,
ties, etc., that could get drawn into the air inlet. To make sure
long hair does not get drawn into the air inlet, tie back long hair.
Maintenance
Please contact an authorized Snow Joe
®
+ Sun Joe
®
dealer
or call the Snow Joe
®
+ Sun Joe
®
customer service center
at 1-866-SNOWJOE (1-866-766-9563) for all maintenance
operations not foreseen in this manual. Any operation
performed in an unauthorized service center or by unqualified
personnel will completely invalidate the warranty.
m
WARNING!
Remove the battery before performing any
maintenance task.
If the battery is still connected, the unit could be accidentally
turned on while you are performing maintenance on it, which
could result in personal injury.
Drain the Tank
1. The tank must be drained and cleaned every time after
vacuuming. Remove the drain outlet cap by turning it
clockwise and use the drain outlet to drain the liquid
waste in the tank (Figs. 20 – 21), or remove the powerhead
to pour out any debris or dust from the tank (Fig. 22).
Rinse the tank with warm water if needed. Allow it to dry
completely.
Fig. 18
Air regulation handle
Air block
Fig. 19
Telescopic tube
Telescopic tube
lock
Fig. 20
Drain
outlet cap