10
IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
Assembly
m
WARNING!
To avoid serious personal injury, read and
understand all safety instructions provided.
m
WARNING!
Do not insert battery until assembly is
complete. Failure to comply could result in accidental starting
and possible serious personal injury.
m
WARNING!
Before performing any maintenance, make
sure the battery is removed from the tool. Failure to heed this
warning could result in serious personal injury.
m
WARNING!
To prevent personal injury, make sure the
switch is in the OFF position before attaching or removing the
suction hose.
1.
Unlock the powerhead by flipping up the latches on both
sides, and then lift up (Fig. 4).
2. Remove all the contents from the tank.
3. Turn the dust tank upside down. Fit a caster into the
mounting as shown. Fix with provided screw. Do not
overtighten (Fig. 5).
4. Repeat to assemble all the 5 casters on the bottom (Fig. 6).
NOTE: The assembly requires 5 screws. The 3 additional
screws are spares.
5. Turn the dust tank back over onto the casters. Cap it with
the powerhead with the desired filter attached. Flip up the
two latches located on either side of the dust tank. Press
in on the two latches located on either side of the dust
tank until they snap into place, securing the powerhead to
the tank (Figs. 7 – 8).
NOTE: For dry vacuum cleaning, install the supplied cartridge
filter and the dust bag. For wet vacuum cleaning, install the
supplied foam filter. See page 12-13 for instructions on how to
install the filters.
Fig. 4
Latch lock
Latch lock
Fig. 5
Caster
Screw
Fig. 6
Powerhead
Fig. 7
Dust tank
Fig. 8
Flip up
1
Press
2