8
Unpacking
Carton Contents:
• Cordless snow blower with lower handle
•
Upper handle assembly
• EcoSharp
®
PRO 40 V 6.0 Ah battery (2)
• EcoSharp
®
40 V dual port battery charger
• Safety key (2)
• Handle knob (4) + bolt (4)
• Discharge chute assembly
• Chute clean-out tool
• Chute nuts (4)
• Shear bolt (2) + gasket (2) + nut (2) (Extras)
• Hex key
• Manual with registration card
1. Carefully remove the cordless snow blower and check to
see that all of the above items are supplied.
2. Inspect the product carefully to make sure no breakage or
damage occurred during shipping. If you find damaged or
missing parts, DO NOT return the unit to the store. Please
call the Snow Joe
®
+ Sun Joe
®
customer service center at
1-866-SNOWJOE (1-866-766-9563).
NOTE: Do not discard the shipping carton and packaging
material until you are ready to use the cordless snow
blower. The packaging is made of recyclable materials.
Properly dispose of these materials in accordance with
local regulations or save the packaging for long-term
product storage.
IMPORTANT! The equipment and packaging material are
not toys. Do not let children play with plastic bags, foils
or small parts. These items can be swallowed and pose a
suffocation risk!
Assembly
m
WARNING!
To avoid serious personal injury, read and
understand all safety instructions provided.
m
WARNING!
Unpacking and assembly should be
completed on a flat and stable surface, with adequate space
for moving the machine and its packaging.
Tools and supplies required:
• Hex key
(included)
•
Tire gauge
Assembling the Handles
m
WARNING!
Observe the lower rear area of the snow
blower and be careful not to damage cable sleeve when
rotating the handle upward.
1. Rotate the handlebars into operating position.
2. Slightly spread the upper handle assembly down over the
lower handle until it slides into position (Fig. 1).
3.
Adjust upper handle assembly to the optimal position
by aligning the double bolt holes at the desired height.
Secure the connection using the 4 handle knobs and
bolts, and tighten on each side (Fig. 2).
Fig. 1
Upper
handle
assembly
Spread the
upper handle
Handle
knob +
bolt
Lower
handle
Cable
sleeve
(BACK VIEW)
1
2
3
Fig. 2
3-position
handle
height
adjustment
