20
8.
Remove 2 set of shear bolts, gaskets and nuts from the
auger (Fig. 36).
9. Remove the auger bearings on both ends then remove the
2 auger blades from the auger shaft (Fig. 37).
10. Install the replacement auger blades by following the
above steps in reverse order.
Replacing Impeller
1.
To uninstall the impeller, repeat steps 1 to 7 (Figs. 29 – 35).
2. Disassemble the worn impeller from the impeller shaft by
removing the 2 spring pins (Fig. 38).
3. Install the replacement impeller by following the above
steps in reverse order.
Replacing Auger Belt
1. Open the battery compartment cover and remove the 2
screws inside the compartment (Fig. 38).
2. Disassemble the motor cover by removing the 4 screws
and washers (2 on each side) and open the motor cover
(Figs. 39 & 40).
3. Remove the M6 bolt and sprocket cover from sprocket 1
then remove the auger belt from pulley 1 (Fig. 41).
Fig. 36
Shear
bolt
Nut
Gasket
Auger
Fig. 37
Auger bearing
Auger shaft
Auger blade
Fig. 38
Spring pin
Impeller
shaft
Impeller
Fig. 39
Screw
Battery
compartment
cover
Screw +
washer
Fig. 40
Open motor cover
Fig. 41
Auger belt
Sprocket cover
M6 bolt
Sprocket
1
Pulley
1
