SNOWJOE iON24SB-XR, Руководство оператора

Страница: 14 / 28

14
Always orient the discharge chute in the opposite direction
from where the operator, bystanders, surrounding vehicles, or
windows are located.
Scraper Blade
The scraper blade allows the back of the housing to keep
better contact with the surface being cleared. It also prevents
damage to the housing from normal use.
IMPORTANT! DO NOT allow scraper blade to wear too far or
auger/impeller housing will become damaged.
Skid Shoes
The skid shoes control the distance between the scraper blade
and the ground. Adjust skid shoes equally to keep blade level
with the ground. (See Assembly section on page 10; fig. 10).
Pre-Start
1. Charge batteries – See Charger Operation section on
page 11.
2. Check function of triggers – If triggers cannot engage or
disengage properly, adjust or repair before operation.
3. Check Skid Shoes – Check and adjust skid shoes (See
Assembly section on page 10; fig. 10).
Emergency Stop
Immediately release both triggers to stop unit in an emergency.
Disengage safety switch, remove key and wait for all rotating
parts to stop before leaving operator’s position.
Operation
m
WARNING!
Failure to follow instructions could result
in personal injury and/or damage to snow blower. DO NOT
attempt to start your snow blower at this time. Read entire
operator manual first.
See page 12 for all controls and features.
m
WARNING!
Keep the area to be cleared free of stones,
toys or other foreign objects that the rotor blades might pick
up and throw. Such items could be covered by snow and are
easy to overlook, so be sure to conduct a thorough inspection
of the area before beginning work.
Starting the Machine
IMPORTANT! Disengage safety switch and release both
triggers before turning power switch to ON position.
1. Open the battery compartment cover and slide two
battery packs down until they both click and lock into
position (Fig. 20). Close the cover.
2. Rotate the safety switch clockwise and pull up the safety
switch. Drive motor will not yet run (Fig. 21)
3. Insert key and turn power switch to the ON position. LED
windows and control panel buttons will glow (Fig. 21).
Fig. 20
Battery
packs
Battery
compartment
cover
Fig. 21
Safety key/Power switch
Safety switch