SNOWJOE iON18SB-HYB, Руководство оператора

Страница: 15 / 20

15
Changing Throw Dir
Throw Height
m
WARNING!
Never direct the snow discharge chute at
the operator, at bystanders, at vehicles, or at nearby windows.
The discharged snow and foreign objects accidentally picked
up and thrown by the snow blower can cause serious damage
and personal injury.
Always orient the discharge chute in the opposite direction
from where the operator, bystanders, surrounding vehicles, or
windows are located.
1. The discharge chute can be controlled 180 degrees by
rotating the chute with the remote switch (Fig. 22).
2. The chute deflector on the top of the discharge chute
controls the height of the snow stream. Loosen the knobs
to raise or lower the deflector to the desired height of
snow you wish to throw. Tighten the knobs to secure the
deflector (Fig. 23).
m
WARNING!
Make sure that the chute deflector locks
completely onto the discharge chute. An opening between
the back of the discharge chute and the chute deflector may
allow foreign objects to be picked up by the snow blower and
thrown in the direction of the operator causing serious bodily
injury.
• Do not advance the chute deflector too far forward as this
can cause an opening to appear behind the deflector and
discharge chute.
• Do not overtighten the knobs on the chute deflector
(Fig. 23).
Maintenance
To order genuine replacement parts or accessories for the
Snow Joe
®
iON18SB-HYB hybrid snow blower, please visit
snowjoe.com or contact the Snow Joe
®
+ Sun Joe
®
customer
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
Make sure to turn off the switch, remove
the battery, and disconnect the power cord before performing
any maintenance task on your snow blower.
Lifetime Lubrication (Motor + Auger)
Lubrication is not necessary and may damage the unit. The
snow blower is lubricated for lifetime use at the factory before
shipment.
General Maintenance Tips
1. Do not attempt to repair the machine unless you have the
proper tools and instructions for disassembly and repair of
the machine.
2. Check bolts and screws at frequent intervals for proper
tightness to ensure that the equipment is in safe working
condition.
3. After each snow removal session, run the snow blower for
a few minutes to prevent the auger/impeller from freezing.
Shut off the motor, wait for all revolving parts to stop
completely, and wipe residual ice and snow off the unit.
Rotate the chute deflector by the remote switch several
times to remove any excess snow.
Proper Care for B Charger
m
WARNING!
To reduce the risk of injury, always unplug
the charger and remove the battery pack from the charger
before performing any maintenance task. Never disassemble
the battery pack or charger. Contact your Snow Joe
®
+
Sun Joe
®
dealer or the Snow Joe
®
+ Sun Joe
®
customer
service center for ALL repairs.
1. To reduce the risk of injury and damage, never immerse
your battery pack or charger in liquid or allow any liquid to
flow inside these components.
2. Clean out dust and debris from charger vents and
electrical contacts by blowing with compressed air.
3. Use only mild soap on a damp cloth to clean the battery
pack and charger, keeping away from all electrical
contacts. Certain cleaning agents and solvents are
harmful to plastics and other insulated parts. Some of
these include gasoline, turpentine, lacquer thinner, paint
thinner, chlorinated cleaning solvents, ammonia and
household detergents containing ammonia. Never use
flammable or combustible solvents around battery packs,
battery chargers or tools.
Fig. 22
Chute remote switch
Fig. 23
Deflector knobs