10
Discharge Chute Assembly
1.
Place the chute deflector so it rests securely in place over
the discharge chute.
2.
Insert the washers into the middle of the chute connection,
pass the carriage bolts through from the inside of the
chute, and tighten with the deflector knobs on each side
(Figs. 5 & 6).
NOTE: Do not overtighten the knobs.
3.
To adjust the height of the snow stream, loosen the knobs
and raise or lower the chute deflector to the desired
height, then re-tighten.
Battery Pack Operation
The equipment is powered by a lithium-ion battery. The battery
pack is completely sealed and maintenance free.
Battery Charge Level Indicator
The battery pack is equipped with a push button for checking
the charge level. Simply press the push button to read off the
battery charge level from the LEDs of the battery indicator:
• All 3 level monitoring LEDs are lit: Battery charge level
is high.
• 2 level monitoring LEDs are lit: Battery charge level is
decreasing. Stop work as soon as possible.
• 1 level monitoring LED is lit: Battery is flat. Stop work
IMMEDIATELY and charge the battery. Otherwise the
battery’s service life will be greatly shortened.
NOTE: If the charge level button does not appear to be
working, place the battery pack on the charger and charge as
needed.
NOTE:
Immediately after using the battery pack, the charge
level button may display a lower charge than it will if checked
a few minutes later. The battery cells “recover” some of their
charge after resting.
Charger Operation
m
WARNING!
Charge only EcoSharp
®
iBAT40 lithium-ion
battery packs in compatible EcoSharp
®
iCHRG40 lithium-ion
battery chargers. Other types of batteries may cause personal
injury and damage.
To reduce the risk of electric shock, do not allow water to flow
into the charger's AC/DC plug.
When to Charge the EcoSharp
®
iBAT40
Lithium-Ion Battery
NOTE: The EcoSharp
®
iBAT40 lithium-ion battery packs do
not develop a "memory" when charged after only a partial
discharge. Therefore, it is not necessary to run down the
battery pack before placing it into the charger.
• Use the battery charge indicator lights to determine when to
charge your EcoSharp
®
iBAT40 lithium-ion battery pack.
• You can "top-off" your battery pack's charge before starting
a big job or after a long day of use.
Fig. 5
Washers
Chute deflector
Fig. 6
Deflector knob
Carriage bolt
Charge level button
The battery is at 30% capacity
and requires charging
The battery is at 60% capacity
and requires charging soon
The battery is at full capacity
Light Indicators
Lights
Содержание iON18SB-HYB
Страница 20: ...snowjoe com...