11
Discharge Chute Assembly
1.
Slide the chute deflector onto the discharge chute, as
shown (Fig. 8).
2.
Insert the washers into the middle of the chute connection,
pass the carriage bolts through from the inside of the
chute, and tighten with the deflector knobs on each side
(Figs. 9 – 10).
m
CAUTION!
Ensure the carriage bolt is fully aligned with
square hole on the chute to ensure a secure fit. Then, tighten
completely.
Operation
m
WARNING!
Keep the area to be cleared free of stones,
toys or other foreign objects that the auger blades might pick
up and throw. Such items could be covered by snow and are
easy to overlook, so be sure to conduct a thorough inspection
of the area before beginning work.
NOTE:
Before using this machine, make sure that the snow
blower’s auger blades are firmly secured with screws. Perform
a test run to ensure that the auger turns freely.
St Stopping
1. Open the battery compartment cover and slide both
battery in until they click to lock it into position. Close the
battery compartment cover (Fig. 11).
2.
While depressing the safety switch button, pull the
switch bar lever toward you. Once the machine powers
on, release the safety switch button and begin operation
(Fig. 12). The machine can only be started by depressing
the safety switch button first, followed by squeezing
the switch bar lever; reverse operation will not start the
machine.
3.
To power off, release your grip on the
switch bar lever.
Fig. 8
Chute deflector
Discharge chute
Washer
Fig. 9
Knob
Fig. 10
Carriage bolt
Washer
Fig. 11
Battery packs
Battery compartment
cover
Fig. 12
Switch bar lever
Safety switch
button
