7
4. Grease with non-freezing lithium lubricant (for
example, TEXACO STARPLEX EP 2) the places where
the shaft bushings slide both on inside and outside
surfaces.
5. Grease the rollers and rolling surfaces with a non-
freezing lithium lubricant (for example, TEXACO
STARPLEX EP 2).
6. Assemble the CVT.
!
Warning :
NEVER ALLOW THE LUBRICANT TO
GET ON THE WORKING SURFACE OF
THE CVT (where the belt runs.)
17.4 Track tension check.
Before starting any movement check the condition and tension
of the track. Over tension leads to engine power loss and
causes overloads. Place the motor tow on a fl at surface. Place
a rigid metal of wooden «straight edge» on top of the track
supported by the front and back rollers. Measure the distance
between the «straight edge» and the track in the the middle
of its length. Normally the track will sag on 0.6-0.8 in (in the
middle of its length) under its own
weight.
V
If your model is equipped with a
track support roller, its needs to
be temporarily removed before
measuring the tension.
17.5
Track tensioning.
Loosen the screws 1 on both sides of the rear mounting shaft.
Turn eccentric 2 to adjust the tensioner axis.
V
NOTE:
V
To eliminate track distortion,
eccentric tensioner should be evenly
set with the right and left side of the
motor tow.
Check the track tension. Tighten the bolts.
