5
11
Storage
Motor tow should be stored in a dry ventilated room or outdoors
under a canopy with a waterproof cover. In case of a short-term
storage (up to one month), perform the procedures specified in
paragraph 10.4. In case of a long-term storage (over a month)
perform all the procedures specified in paragraph 10.4 and
lubricate non-coated parts with a preserving agent, as well as the
parts where paint-and-lacquer coating is exposed. This ensures
the safe preservation of the motor tow for up to 12 months when
stored normally. For the next 12 months of storage, reproduce
the steps above. To do so, follow the engine depreservation
procedures specified herein, remove the preserving agent from
the parts, fill the tank with gas, start the engine and let run for
5 minutes, then stop it, change the engine oil, and preserve the
motor tow for another period.
Also follow the engine manufacturer recommendations for long-
term storage.
11.1 Track maintenance
Check the track condition and its tension after each trip.
Excessive track tension is offen the reason for power loss and
causes engine overload.
You should also check if the track’s position is symmetrical to
the motor tow. Never operate the motor tow with severe track
damage. In case of severe track damage, you should seal it to
prevent moisture from ruining the track’s cord.
The cord threads should not stick out of the track’s side. If they
do, cut them off.
Check the track’s metal brackets after each trip. if bent,
straighten. If a bracket is missing, replace it. Operating damaged
tracks leads to their rapid deterioration.
Inspect and clean the track after each trip.
When operating the motor tow in the wet snow, clean the track
more often, especially before a prolonged stop. Do not expose
the track to oil and various chemicals.
Do not store the motor tow under direct sunlight.
Loosen the track before storage.
We recommend storing the motor tow in suspended position. In
case of a long-term storage the track must be rotated to a new
position once a month.
11.2 Transportation
Drain the fuel from the tank or shut down the fuel valve before
transporting. The motor tow must be in a horizontal position
during loading and unloading. When transporting the motor tow,
make sure it is secure.
Motor tows cannot be stacked during transportation.
12
Pre-start engine inspection
12.1
Checking oil level
!
Check the oil level in the engine,
according to the engine manual.
!
Caution
Running the engine with insufficient
oil level will cause damage and is not
covered by warranty.
V
Note
Automatic engine oil level protection
system will switch off the engine if
the oil level falls below a safe level,
but to ensure the safe operation of
the engine it is recommended to
check the oil level before each trip.
13
Fueling
!
Fill the gasoline engine according to
the engine manual.
!
Note
•
Fuel is highly flammable and explosive, you should avoid
getting burned and injured while working with it.
• Stop the engine before refueling. Make sure there are no
heating appliances, sparks or flames around.
• Refuel only outdoors.
• Refuel only in a well-ventilated area and only if the engine is
stopped. If the engine has been recently running, let it cool
down first.
•
Spilled fuel is not only inflammable, but can also harm the
environment. In case of spilled fuel, wipe down as soon as
possible.
14
Starting the engine
1.
Be sure to follow all of the procedures specified in
paragraph 10.1.
2. Prepare the engine for starting, as described in the
engine manual.
3. Lock the parking brake.
4. Set the engine switch to “ON” position.
If you have an electric starter, press the start button electric
start (no more than 5 seconds) and start the engine.
To use the recoil starter rope, pull the cord slowly, before
resistance, then pull strongly.
When the engine starts, allow it to warm up for 2-5 minutes
After warming up the engine, remove the choke lever. Read
more in the engine manual.
Y
Caution
When starting the engine with an
electric starter, do not hold the switch
in “ON” position for more than 5
seconds. If the engine hasn’t started,
you can retry in 10 seconds.
15 Start drive
1. Strap the engine security switch on your hand.
2. Release the parking brake.
Slowly squeeze lever to engage the transmission and to start
the motor tow moving. Increase pressure on the throttle lever
until desired speed is reached.
