SNOWDOG COMPACT B13ME-WR, Руководство пользователя

Страница: 6 / 16

6
!
WARNING
When operating the SNOWDOG at an ambient
temperature of over 41 °F (+ 5 °C), it is
necessary to open the zipper placed in the
front part of the cover or remove the cover.
9.2 Battery installation
It is necessary to install and connect the battery before
using the SNOWDOG. You will need a battery (supplied with
the SNOWDOG), a metric wrench (not included) and a Philips
screwdriver (not included).
Unscrew 2 bracket mounting bolts using metric wrench.
Install the battery, and tighten it with the bracket using the
metric wrench.
Connect the electric wires to the battery, strictly observing
the polarity. Wire with the red cover is connected to the cleat
marked with “+” sign, wire with black cover is connected to the
cleat marked with “-” sign. Tightly secure the с ontacts.
General view of the assembled battery is shown below.
!
WARNING!
Pay attention to the polarity when connecting
the battery!
Do not turn on the headlight if the battery is
not connected!
V
NOTE
The voltage of the charged battery should be
within the range of 12.6 – 12.9 volts. If the
battery voltage is less than 12.6 volts, it must
be charged.
!
WARNING
Use chargers designed for AGM batteries.
Do not use chargers with voltages above
14.6 volts as they will damage the battery.
9.3 Handlebar height adjustment
To adjust the height of the handlebar you must rearrange
fi xture in one of the three holes (1). In order to raise the wheel
higher, move the mounting holes in the bottom. In order to
lower the wheel, move the steering wheel to the upper hole.
Please NOTE, both mountings of the handlebar must be on the
same level.
9.4 Preparations, necessary to maintain
before every start up
1. Move the handlebar from the transporting position
into the operating position.
2. Sleds or semi-trailers are mounted to the motor using
hitch.
3. Check the chain tension — the chain should be neither
loose, nor tight.
4. Check the throttle and brake cable (lubricate
if needed).
5. Check the parking brake.
6. Move the parking brake into the fi xed position.
7. Be sure to follow all of the procedures speci fi ed
in paragraph 9.5 .
8. Prepare the engine for starting, as described in the
engine manual.
9.5 Pre-start engine inspection
9.5.1 Checking oil level
!
CHECK THE OIL LEVEL IN THE
ENGINE, ACCORDING TO THE ENGINE
MANUAL BEFORE OPERATING.
!
CAUTION
Running the engine with insuffi cient oil level
will cause damage and is not covered by
warranty.
9.5.2 Fueling
!
FILL THE GASOLINE ENGINE
ACCORDING TO THE ENGINE
MANUAL.
!
NOTE
• Fuel is highly fl ammable and explosive, you
should avoid getting burned and injured while
working with it.
9.3 Handlebar height adjustment
1