9
|
P a g e
SnowBe
INSTALL 5/8-11x3.50” HEX BOLT
AND WASHER ON RECEIVER
ASSEMBLY SIDE. WASHER AND
NUT ON VERTICAL POST SIDE.
Once your desired height is determined, install the two 5/8
Assembly bracket side, and install washer and 5/8
movement of the spreader assembly on the receiver assembly.
The spreader is ready to install into your vehicle
Hold the spreader assembly up to the 2” hitch receiver, and slide in. There are th
receiver assembly to allow for horizontal
2” from another. When the spreader assembly is slid into the hitch receiver, look to see when one of the
assembly’s holes aligns with the hitch receiver, and install the supplied hitch pin. Insert fully, and install the
supplied r-clip in the hitch pin hole to secure the assembly.
INSTALL SPREADER ASSEMBLY 2”
RECEIVER INTO VEHICLE'S 2”
HITCH RECEIVER. ALIGN ONE
HORIZONTAL DEPTH ADJUSTMENT
HOLE.
R-CLIP
HITCH PIN
4
5
2
3
6
Owner’s Manual
SnowBear
®
Tailgate Spreader (TGS
Once your desired height is determined, install the two 5/8-11x3.50” hex bolts and washers on the 2” Receiver
Assembly bracket side, and install washer and 5/8-11 lock nut on vertical post side. Tighten until there is no
movement of the spreader assembly on the receiver assembly.
eady to install into your vehicle's hitch receiver.
spreader assembly up to the 2” hitch receiver, and slide in. There are three holes in the spreader’s 2”
receiver assembly to allow for horizontal depth adjustment in the vehicle’s hitch receiver. Each hole is spaced
2” from another. When the spreader assembly is slid into the hitch receiver, look to see when one of the
’s holes aligns with the hitch receiver, and install the supplied hitch pin. Insert fully, and install the
in the hitch pin hole to secure the assembly.
INSTALL SPREADER ASSEMBLY 2”
ADJUSTMENT
ONCE DESIRED HOLE IS ALIGNED,
INSTALL SUPPLIED HITCH PIN AND
R-CLIP TO SECURE ASSEMBLY.
Owner’s Manual
Tailgate Spreader (TGS-325)
11x3.50” hex bolts and washers on the 2” Receiver
Tighten until there is no
ree holes in the spreader’s 2”
hitch receiver. Each hole is spaced
2” from another. When the spreader assembly is slid into the hitch receiver, look to see when one of the
’s holes aligns with the hitch receiver, and install the supplied hitch pin. Insert fully, and install the
ONCE DESIRED HOLE IS ALIGNED,
INSTALL SUPPLIED HITCH PIN AND
CLIP TO SECURE ASSEMBLY.
