Owner’s Manual
14
|
P a g e
SnowBear
®
Tailgate Spreader (TGS-325)
General Maintenance
The SnowBear
®
Tailgate Spreader is generally maintenance free, but there are a few recommendations to
help ensure many seasons of trouble-free operation.
WARNING:
Never remove the spreader with material in the hopper. Always empty before removing.
CAUTION:
•
Disconnect electric power at spreader electrical harness plug connection before servicing or
performing maintenance.
•
When replacing parts, use only original manufacturer's parts. Failure to do so will void warranty.
•
Remote receiver is a solid-state electronic unit and is not serviceable. Any attempt to service will
void warranty.
•
There are no serviceable parts in the motor assembly. Any attempt to service will void warranty.
•
If pressure washing spreader motor/electrical enclosure area, stay at least 48" [1.2m] away and
avoid direct spray on the openings to avoid excessive water intrusion.
•
During removal or mounting, securely grip spreader to avoid dropping.
AFTER EACH USE
•
Do not leave unused material in the hopper. Material can freeze or solidify, causing unit to not work
properly. Empty and clean after each use.
•
Wash out hopper & rinse off all external surfaces, especially spinner and deflector areas.
•
Apply dielectric grease on 4-pin connector plugs to prevent corrosion.
AT THE END OF EACH SEASON OR AFTER EXTENDED STORAGE
•
Wash out hopper & rinse off all external surfaces.
•
Apply dielectric grease on 4-pin connector plugs to prevent corrosion.
•
Paint any bare, non-stainless steel, metal surfaces to prevent corrosion.
STORAGE
•
Store the spreader in a clean, dry location and preferably away from direct sunlight.
