324-128
Drop Kit
Installation
Instruction
5
|
P a g e
SnowBear
®
Drop Kit Installation - 324-128
Step 3:
Install single Drop Kit Plate as shown in below diagram. Only do one side (Left or Right) only at this time (Left
side shown). Install Drop Kit Plate between Winch Arm & Receiver Weldment with 1/2"-13 x 2" Hex Bolts &
Nuts (as supplied in Hardware Kit) (x4). Fasten hardware completely.
Step 4:
Install A-Frame Weldment into one of the two lower holes on the Drop Kit Plate on the side installed.
Left
Right
1/2"-13 Hex
Bolts & Nuts
Drop Kit Plate between
Winch Arm & Receiver
Weldment
Drop Kit
Plate Holes
