![SNOWBEAN SBGPS-TK102 Скачать руководство пользователя страница 12](http://html1.mh-extra.com/html/snowbean/sbgps-tk102/sbgps-tk102_operational-manual_1309736012.webp)
Page 12
12
12
12 of 16
16
16
16
5.21.
Sleep Mode
Sleep by time:
Send "sleep+pspace+time", tracker will reply "sleep time ok" if none of the
alarms listed under chapter IV has been set and no operations, tracker will fall asleep in 5 minutes,
LED will be off, calling or SMS can awake the tracker. If these alarms have been set, tracker will enter
sleep by detecting shock sensor. And tracker will sleep by time as default.
Sleep by shock sensor:
Send "sleep+pspace+shock", tracker will reply "sleep shock ok", it
will enter sleep mode after detect no shock, and LED will be off.
Forward the third parties’ message
Send SMS "PSPACE+THIRD PARTIES PHONE NUMBER" from authorised
phone number, tracker will reply "forward ok", and supports 1 third parties phone numbers at most.
For example, set the phone number of the service provider of the SIM card in the tracker, when
charge remind message coming in, tracker will forward it to authorised phone number.
Cancel: Send SMS command "NOPASSWORD".
Charges Inquiry
Send SMS command "PSPACE+PHONE SPACE+CONTENT" to
tracker, it will forward the content to the specified phone number and return the content from the
specified phone number.
5.22.
State Checking:
Send SMS:”CHECK+PASSWORD” to the tracker device, it will reply the recent status via SMS as:
GSM: 100% GPS: OK/NO GPRS: ON/OFF battery: 100%.
5.23.
IMEI checking:
Send SMS command "IMEI+PASSWORD" to the unit.
E.g.: Send SMS command "IMEI123456" to the unit, an
IMEI number in 15 digits will be replied to your cell
phone.
5.24.
Terminal (local) Time Setting:
Send SMS “TIME+SPACE+ZONE+PSPACE+LOCAL TIME ZONE OFFSET”. For
example, Send SMS “TIME ZONE123456 10” (Time zone offset of New South Wales, Australia). If the
local time zone is negative as “-8”, then it should set as SMS: “time zone123456 -8”. Reply SMS:
Time OK
5.25.
TCP/UDP switch:
Command: "gprs123456,0,0" TCP with keep alive data, this is the default mode.
Command: "gprs123456,0,1" UDP with keep alive data
Command: "gprs123456,1,0" TCP without keep alive data
Command: "gprs123456,1,1" UDP without keep alive data