Page 10
10
10
10 of 16
16
16
16
For Example: send SMS: “load123456 20110425” to the tracker device, means to load the tracking
data of 25th April 2011 to monitoring platform.
5.15.
Shock Sensor Alarm
Setup:
Shock sensor alarm is deactivated in default settings. If needed, please send an SMS
“SHOCK+PASSWORD” to tracker device, and it will reply “SHOCK IS ACTIVATED!”, it means
shock sensor alarm has been set up successfully. When the tracker detect vibration, it will send an
SMS “SENSOR ALARM+GEO-INFO” to authorised numbers.
Note: Shock sensor detect vibration one time for each 3 minutes, it will start to detect the second
shock sensor alarm 3 minutes after the first alarm.
Cancel: Send "password" to cancel the shock sensor alarm.
Shock sensor sensitivity configuration:
The sensitivity of the built-in shock sensor has three different levels:
First level:
Alarm will be triggered after detect slight vibration, send command "senspspace+1".
Second level:
Alarm will be triggered after detect 8 times vibration in 2 seconds, send command "senspspace+2".
Third level:
Alarm will be triggered after detect 25 times vibration in 5 seconds, send command "senspspace+3".
5.16.
Geo-fence
Set up a geo-fence for the unit to restrict its movements within a district. The unit will send the
message to the authorised numbers when it breaches the district.
Set up:
When the unit stays immobile in a place for 3-10 minutes, the user can Send SMS:
“SPSPACE+LATITUDE,LONGITUDE; LATITUDE,LONGITUDE” to unit to set
the restricted district. In case of breach, it will send SMS “STGEO-INFO” to the authorized
numbers Every 3 Minutes.
Note: The first LATITUDE&LONGITUDE (marked “A” in figure) is coordinate of the top left corner of
the Geo-fence, while the second LATITUDE&LONGITUDE (marked “B” in figure) is the coordinate of
the bottom right corner.
