26
27
TOUCh SCREEN OPERATIONS
TOUCh SCREEN CALIBRATE
When “Power Off”, press the buttons 1, 2, 3, 4, 5, [BAND] of remote control to enter the
CALIBRATE page:
To touch the points from 1 to 5 until the points change to brighter by using a ballpoint
pen or pencil.
After all 5 points change to brighter, the unit would finish the CALIBRATE and will
power off again. Then the Touch Screen calibration is complete.
Brake Control
It is necessary to connect the Brake Control wire to the Hand-brake switch of the car.
While driving, the TFT monitor will display the alarm picture (see as follows) in order to
ensure the safety.
Under the Rear View Mode, the Brake Control function is no effective.
Protection of the TFT Monitor
During the movement of the TFT monitor, if it is halted by force, then the unit will begin
self-protection to prevent from any damage on the motorized mechanical structure.
Press the [OPEN] button or shut down the ACC and then restart, the TFT monitor will
act as the follow list to recover; if not, then please consult with an authorized service
center.
Halt
Self-protection
Press the [OPEN]
button
Shut down the ACC
and restart
While extending
Retraction
Extending
Retraction
While retraction
Stop at the halt place and
retract after 3 seconds
Extending
Retraction
While turning
upward
Turning downward and
retraction
Extending
Turning downward
and retraction
While turning
downward
Stop at the halt place
Turning downward
and retraction
Turning downward
and retraction
