5 of 18
Sno-Pro Fast-Cast 550 Spreader
1D.
(continued)
Failure to attach this Chain
may result in an accidental
Body Dump, damaging the
Spreader, the Utility Vehicle,
persons seated in the Vehicle,
or standing nearby.
Section 2. Operating Instructions
2A. Engine Starting and Cab Controls (Gas Motors)
Step 1.
Verify that the '
ON/OFF
' Switch is in the
'
ON/RUN
' position on the Cab Control Panel.
Step 2.
Go to Engine at the rear of Spreader.
Move the Throttle Control to the '
FAST
'
Position.
Push Primer Bulb firmly 3-5 times.
Grasp Rope Handle and pull cord rapidly
to start Engine.
(See Engine manual for details.)
Step 3.
From the Cab Control Panel, flip the
Conveyor Switch to the '
ON
' position.
This will engage the Conveyor Chain and
Spinner Disc.
Figure 3. 1CS6E-C Electric Spreader Cab Control
2B. Electric Spreader and Cab Controls
Step 1.
Verify that the '
ON/OFF
' Switch is in the
'
ON
' position on the Cab Control Panel.
This will engage the Conveyor Chain and
Spinner Disc. The Green Indicator Light will
come on.
Step 2.
Spin Speed Controller to desired speed setting.
Step 3.
An additional amount of material can be
spread in spots by toggling the '
BLAST
' Switch.
The Switch can also be held on for increased
dispersal when needed.
The Yellow indicator light illuminates whenever
the '
ON
' switch is toggled to indicate a 3-Spin
Burst spin is occuring to clear the
Spinner/Conveyor System on the Spreader.
The Spreader will then operate at the speed
setting on the dial.
The Red Indicator Light illuminates when the
is overloaded. Stop the Spreader functions and
check the Spreader for material problems in the
Spinner/Conveyor and the Gate area where it
feeds from the Hopper before resuming.
2C. Gate Height Adjustment Steps
Step 1.
Loosen two Gate Screws.
Step 2.
Adjust Gate to desired height.
Step 3.
Tighten Gate Screws.
WARNING
