11 of 25
Home-Pro 3000 Assembly Instructions
1" x 3-7/8" Hollow Pin
1/2"-13 x 5" Bolt
1/2" Flat Washer
1/2" Flat Washer
1/2"-13 Lock Nut
NOTE:
2-PERSON LIFT
Section 3. Mount A-Frame to Trip Frame
A.)
With Moldboard remaining face down, lift A-Frame assembly over the Trip Frame (with assistance,
A-Frame is very heavy) and lower it into the center hole of Trip Frame. Apply grease and install (1)
1" x 3-7/8" Hollow Pin (1TBP127) through the Trip Frame and A-Frame. With Hollow Pin in position,
install (1) 1/2"-13 x 5" Bolt with a Flat Washer down through the Hollow Pin. Fasten loosely with a 1/2"
Flat Washer and Lock Nut,
Do not
fully tighten at his time.
See Figure 3 below.
B.)
Swing A-Frame to Left or Right and align hole in Angle Cylinder Ram with corresponding hole in Trip
Frame. Install (1) 1" x 4" Clevis Pin (1TBP23) through Trip Frame and Angle Cylinder Ram.
Secure Clevis Pin with (1) 3/16" x 2" Cotter Pin (1TBP24). Swing A-Frame to opposite side and
repeat alignment and pinning procedure.
See Figure 4.
C.)
Swing A-Frame back to center position and torque the 1/2"-13 Lock Nut (installed in Step A.)
to 75 ft/lbs.
Do not
over tighten, the A-Frame must pivot freely.
Figure 3. Mount A-Frame to Trip Frame
