Snell IQOTR40, Руководство пользователя, Страница: 14 / 28

IQOTR40/41/42/43/44/45/99 www.snellgroup.com
SDI-Inputs 1-4 Screen
The SDI-Inputs screen enables the:
•
Inputs and outputs to be configured.
•
The configuration mode to be used selected.
•
The rules governing configuration use to be specified.
SDI Inputs 1-4
•
SD/DVB-ASI (270 Mb):
•
HD (1.5Gb):
•
3G (3 Gb):
•
Others: Check one or more of these checkboxes to determine which types of signal are
deemed to be valid for a particular input. If a signal is present on the input but not selected
as valid, its status will be
Error . Others is for signals of type other than the above. Also,
because the reclockers are on the outputs , if an input is detected as present but not routed
to an output, its bit rate will be unknown and its status would be Error unless this box was
checked.
•
Reclock Bypass: Check this to bypass the reclocker, which is on the output signal.
•
The Channel Ident , I/P Name , I/P State and I/P Rate are shown for each channel.
Config 1 and Config 2
Use the radio buttons to specify the SDI input for each of the four Fiber outputs.
Select Laser Off On Inp Err to apply a mute to the output if there is no valid signal on its input as
defined by the checkboxes; includes signal lost. Select Laser Off to manually apply a mute to the
output.
Issue 1 Rev 2 © 2012 Snell Limited Page 14