Snell & Wilcox SD1012, Руководство по установке

Страница: 36 / 53

Page SD1012 Installation Manual - Issue 6, Rev 1 S&W Production & Post Production 28
OTHER INSTALLATION PROCEDURES
Setting the Real-Time Clock
It is recommended that you set the Real-Time Clock at installation time. To do this, press the
CONFIG MENU button, then press
F2L User and then F4L More until F3L is Set Clock, press this
button. F1L & F2L select Date and Time , adjust the rotary controls along the bottom of the screen
to the desired date & time values. When ready, press the F4R Set Clock button.
There is no automatic correction for Daylight Saving Time - in areas where DST is implemented the
clock will have to be manually adjusted twice a year.
For more details about this menu, see User Manual.
System Reboot
If required, the system can be rebooted without powering off and on. This can be done using the
System Reboot button in the Misc – Factory Reset menu.
Alternatively, hold down the four FTB buttons (FTB ENABLE, TIME, CUT & AUTO) at the right-
hand end of the control panel at the same time as the DSK, Program & Preset bus BLACK buttons
at the left-hand end of the control panel. Keep these buttons held down, and after five seconds all
buttons will light green for two seconds, then amber for two seconds, then red for two seconds (all
times approximate). They will then all extinguish and the system will reboot.
No stored data (DMEMs, stills, configs, etc.) will be lost as a result of this process.
System Settings
Following installation of the switcher system, settings of television standard, genlock etc will not
automatically be remembered when the system is switched off .
To set the state on power up, save the current state as System 000 in the Config-System-System
Save menu. Settings such as source remapping and key associations should be saved as Config
000 in the Config-User-Save Config menu. For full details refer to the User Manual.