IQBRT8
SECTION 41b
IQBRT8OPS 020403
Version 1 Issue 7
41b.11
CARD EDGE CONTROLS
LED INDICATORS
D1 and D2
When illuminated, D1 and D2 indicate that the +5V
and the -5V power supplies are present.
D3
When illuminated, D3 will indicate that the selected
locking source has been lost.
AES Input Status
These LED’s indicate the status of the inputs.
The LED will flash if there is no AES signal at that
input. The LED will be OFF if the input is OK.
Take
If a routing assignment has been changed this LED
will flash slowly for approximately 20 seconds,
flash quickly for approximately 3 seconds and then
stop.
The pushbutton should be pressed before the
flashing stops to initiate the change.
