Snapper FRP216012E, Инструкции по безопасности и руководство оператора

Страница: 16 / 28

16
Section 4 - REPAIR & ADJUSTMENTS
WARNING
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for
all components to cool.
4.3.4. Replacing Driven Disc Rubber Ring
(Continued From Previous Page)
2. Using needle nose pliers, unhook the drive
spring and slide the driven disc assembly off the hex
shaft. See Figure 4.12.
3. Remove the five machine screws and plate
which secure the rubber ring to the driven disc hub.
See Figure 4.13.
4. Install new rubber ring.
5. Reverse above procedures for reassembly and
installation.
FIGURE 4.12
FIGURE 4.13
4.3.5. Replacing Bearing In Driven Disc Assembly
If the driven disc bearing fails, remove the driven
disc assembly and replace bearing as follows:
1. Remove snap ring. See Figure 4.14.
FIGURE 4.14
2. Slide the hub assembly out of the bearing.
3. Remove the four screws.
4. Remove bearing and replace with new bearing.
5. Reassemble components in reverse order.
THRUST PLATE
SNAP
RING
SHIM
WASHER
REMOVE FOUR
MACHINE SCREWS
BEARING
DRIVEN
DISC
PLATE
DRIVEN DISC
HUB
RUBBER DISC
DRIVEN DISC
ASSEMBLY
DRIVEN DISC HUB
MACHINE
SCREWS
RUBBER
RING
PLATE