Snapper 7800448, Руководство оператора

Страница: 12 / 120

12
Installing the Grass Bag
(Optional Accessory on Some Models)
1. Remove the mulching cover. Refer to the Section
entitled “Removing the Mulching Cover”.
2. Install the grass bag adapter (A, Figure 11) to the deck
in place of the mulching cover, making sure that:
•
The front hole (B) on the outside front of the
adapter fits over the stud where the front of the
mulching cover was originally secured
• The slot (C) on top of the adapter slips under the
restraining nut on top of the deck (under the right
front corner of the engine)
• The slot (D) on the rear of the adapter slips onto
the stud behind the rear of the discharge opening,
where the rear of the mulching cover was
originally secured.
3. Install the internal/external tooth lock washers and knob
nuts onto the studs and tighten securely.
4. Route the recoil rope around the outside of the rope
guide pulley (E) .
Note: The recoil rope can be slackened by squeezing the
blade control against the handle.
5. Install the grass bag by sliding the connector (A, Figure
12) over the adapter flange.
6. Attach the grass bag hooks (B) over the middle handle
cross bar.
www.snapper.com
WARNING
Grass Catcher bags are made of woven fabric, and are
subject to deterioration and wear during normal usage.
Check condition of bag before each use. Immediately
replace worn or damaged catcher bags with only bags
recommended by the manufacturer. The grass catcher
is optional equipment on some models.
! !
Figure 11: Installing the grass bag adapter
Figure 12: Installing the grass bag
B
A
B
D
A
E
C
WARNING
DO NOT attempt any maintenance, adjustments or service
with engine and blade running. STOP engine and blade.
Disconnect spark plug wire and secure away from spark
plug. Engine and components are HOT. Avoid serious
burns, allow sufficient time for all components to cool.
!
!
Operation
Not
for
Reproduction
Not
for
Reproduction