15
Tire
Pressure
Front
25 psi (1,72 bar)
Rear
15 psi (1,03 bar)
Figure 8. Checking Tire Pressure
Check Tire Pressures
Tire pressure should be checked periodically, and maintained
at the levels shown in the chart. Note that these pressures
may differ slightly from the “Max Inflation” stamped on the
side-wall of the tires. The pressures shown provide proper
traction, improve cut quality, and extend tire life.
How to Prepare the Engine
NOTE:
The engine was shipped from the factory filled with
oil. Check the level of the oil. Add oil as needed.
NOTE:
The operation of a new engine will sometimes result
in a slight amount of smoke. This smoke is caused by paint
or oil on or around the muffler. This is normal and only
expected during initial operation.
A separate engine manual is also included with the unit. See
this engine manual for the manufacturer’s instructions for
the type of oil and gasoline to use. Before you use the unit,
read the information on safety, operation, maintenance and
storage.
IMPORTANT:
This unit is equipped with an internal
combustion engine and must not be used on or near any
unimproved forest-covered, brush-covered or grass-covered
land unless the engine’s exhaust system is equipped with a
spark arrestor meeting applicable local or state laws (if any).
If a spark arrestor is used, it must be maintained in effective
working order by the operator.
In the state of California the above is required by law
(Section 4442 of the California Public Resources Code).
Other states may have similar laws. Federal laws apply
federal lands.
In some areas, local laws requires the use of a resistor spark
plug to control the ignition signals. See an Authorized
Service Center for a resistor spark plug for the engine.
NOTE:
Actual sustained horsepower will likely be lower due
to operating limitations and environmental factors.
WARNING
Follow the engine manufacturer’s instructions for the
type of gasoline and oil to use. Always use a safety
gasoline container. Do not smoke when adding
gasoline to the engine. When inside and enclosure, do
not fill with gasoline. Before you add gasoline, stop
the engine. Let the engine cool for several minutes.
